Bobcat Grader Adaptor Harness | SG-BPH-GW-100

Thoughtful delivery service

Easy 30 day returns

Certified Reviews

Description

Bobcat Grader Adaptor Harness | SG-BPH-GW-100Pre wired bypass harness for running a Bobcat 84 inch or 96 inch grader on any 14 pin equipped skid steer loader. Bypasses the Bobcat Gateway Controller and wires directly to the attachment solenoids, allowing operation from the machine's standard 14 pin port. Machine side connector: Deutsch HD 14 pin female Attachment side: solenoid leads for Bobcat grader solenoids Compatible machines: Case, Gehl, Kubota, JCB Volvo, Mustang, Takeuchi, New Holland,

This is the standard output connector used on CB-4000

Breakout test box for Deutsch HD 14-pin attachment connectors

Includes: controller and required wiring for complete installation

Provides consistent

4 female CAN bus sockets

For running attachments with spade lug solenoid connections from any 14-pin equipped skid steer loader

Typical use: single-function Chinese or aftermarket attachments with 14-pin connectors

*For Cat you may be required to move two pins depending on the attachment as well as remove the high flow sense pin in the attachment socket to avoid blowing the machine fuse

Splits the laser receiver signal output into two parallel Delphi 2-pin paths — allows simultaneous connection of two laser-controlled receivers or actuators from a single laser receiver output

Connector type: Delphi Metri-Pack 2-pin on all three legs

Crimps: Deutsch HD #12 and #16 contacts (pins and sockets)

Use to splice a Skid Steer Genius controller output directly to an attachment solenoid or custom harness

Exchange/Return Notes